Honeywell pro 3000 access control installation manual

HONEYWELL PRO 3000 ACCESS CONTROL INSTALLATION MANUAL DOWNLOAD

The actual temperature did fall to 71 or up to 73 and that is what turned on the heating or cooling but the thermostat display will stay at 72 to avoid jumping up and down constantly. For example, if you have the thermostat set to 72 degrees the system will turn on and off but the inside reading on the thermostat never changes from 72.

Also, Honeywell thermostats do round in the display to the nearest whole number (half number in Celsius) and to the temperature setting. Room thermometers often only read ambient air temperature so they will not match the thermostat reading. This means the thermostat takes into account not just the ambient air temperature but also the radiant temperature of objects in the room (i.e., wall and furniture). Honeywell digital thermostats are designed to display the room temperature in a way similar to how people sense temperature. The installer can adjust the cycle rate setting on the thermostat. A typical high efficiency furnace or hot water system would cycle less than that. How often your heat turns on and off depends on several factors including the type of heating system you have and load conditions (in other words, how hot or cold it is outside).ДЄ typical mid-efficiency forced air system will cycle about five times in an hour (5CPH) under typical load conditions. Your thermostat is designed to control temperature to +/- 1 F. If you are unsure about your voltage, please contact a local heating and cooling contractor in your area for assistance. Regardless of the voltage, Honeywell strongly suggests that you turn off the power to the system at the furnace, at the fuse, or at the circuit breaker panel before installing or replacing a thermostat. This type of voltage is common with electric baseboard heating. If you see 120 Vac or 240 Vac on the thermostat, a low voltage thermostat will NOT work with your system. The old thermostat may say somewhere on the thermostat that it is for 24 volt (24Vac) or maximum 30 volts (30Vac). The most common type of voltage from a central heating and/or cooling system is 24 volts (24Vac).

HONEYWELL PRO 3000 ACCESS CONTROL INSTALLATION MANUAL DOWNLOAD

Free Download Video Klip Zaskia Gotik Satu Jam Saja. Honeywell offers thermostats for both low voltage (24 volts) and line voltage (120 or 240 volts) systems. The Circ (Circulate) position if available will run the fan approximately 35% of the time, minus any time the fan will run with the heating or cooling system. The On position will turn the fan on to run continuously, regardless whether heating or cooling system is turned on by the thermostat or not.

The Auto position will allow the system fan to operate whenever the heating or cooling system is turned on by the thermostat. The FAN selection key has two or three positions: Auto and On and sometimes Circ (Circulate). If your thermostat has a mechanical clock, the model number is on a sticker on the horizontal surface above the clock. You can also check this list of our to find your model number. If the thermostat is battery operated and the batteries are accessed from the front of the thermostat, please check the area around the batteries. After removing the thermostat, flip it over and look for the model number, which is printed on the back of the case, starting with the group of letters mentioned above. Depending on your model, the thermostat will separate from the wall-plate with moderate pressure or there might be small screws holding the device in place. If you do not have a product ID card, the fastest way to find the model number is by removing the thermostat from the wall-plate.

The fastest way to see your thermostat model number is to look for it on your thermostat ID card. NexWatch never recommends using the PW-3000 or related pro 3000 honeywell installation manual.

Honeywell pro 3000 access control installation manual